CORBA Mountain Biking Photos. Click on an image to see it full size.
![Image1.jpg](tn_Image1_jpg.jpg) |
The trail on Feb 23, a couple of days before trailwork
|
|
![Image5.jpg](tn_Image5_jpg.jpg) |
The trail on Feb 23, a couple of days before trailwork
|
|
![Image6.jpg](tn_Image6_jpg.jpg) |
The trail on Feb 23, a couple of days before trailwork
|
|
![Image8.jpg](tn_Image8_jpg.jpg) |
The trail on Feb 23, a couple of days before trailwork
|
|
![SAM_0705.jpg](tn_SAM_0705_jpg.jpg) |
Clearing the brush to widen the trail. This is near the bottom of Guadalasca
|
|
|
|
|
|
![SAM_0711.jpg](tn_SAM_0711_jpg.jpg) |
We're concentrating on removing brush from the the downslope side (outside of the trail; on the left in this photo).
|
|
![SAM_0712.jpg](tn_SAM_0712_jpg.jpg) |
Later on, the trail will be moved to the downslope side and outsloped so the rainwater will run off it, rather than down the middle.
|
|
![SAM_0713.jpg](tn_SAM_0713_jpg.jpg) |
When the trail is moved over, the ruts in the middle will be filled in and the upslope brush will grow in where the trail used to be
|
|
|
![SAM_0717.jpg](tn_SAM_0717_jpg.jpg) |
In the end, the trail will narrow back down to a singletrack and will be much easier to maintain.
|
|
![SAM_0718.jpg](tn_SAM_0718_jpg.jpg) |
State Park employee Dale uses a 'pole saw' to cut through thicker and higher branches. It made our work much easier!
|
|
![SAM_0719.jpg](tn_SAM_0719_jpg.jpg) |
State Parks has a Gator to get get our tools up the trail for us.
|
|
|
![SAM_0722.jpg](tn_SAM_0722_jpg.jpg) |
Getting rid of the brush we cut out. It goes down the hill and is out of sight of people who use the trail
|
|
|
|
![SAM_0725.jpg](tn_SAM_0725_jpg.jpg) |
We clear high branches that would impede people where the trail will be moved to, especially tall bikers (like me!) and equestrians
|
|
|
|
|
![SAM_0732.jpg](tn_SAM_0732_jpg.jpg) |
We use a power hedge trimmer to remove the lighter brush
|
|
|
|